What is Ktag 8.000: The updated K TAG 8.000 programmer is designed for reading and writing control units for cars, motorcycles, trucks, agricultural machinery and boats. KTAG is used to program microprocessors in electrical circuits. The software has a clear interface and allows you to quickly master the work with the developer. Updated the firmware to version 7.020. Open All Protocols BDM Motorol...
Pogledaj dalje »Can Xhorse vvdi prog read that ecu? SID208 from Ford Ranger Car: Ford Ranger 3.2td 146 kw ECU: SID208 VVDI Prog: No There is no Ford ECU in the list Ktag: Yes Managed to read data with a Ktag clone! Success with Ktag fw 7.020 with Ksuite 2.23 Source: http://www.obdii365.com/wholesale/ktag-v7020-red-pcb-online-version.html
Pogledaj dalje »How-to: use KTAG V2.22 FW 7.020 to read Bosch ME9.0 ECU Volvo S40. Photo attached: http://www.obdii365.com/producttags/ktag-7020.html
Pogledaj dalje »Question: How do you replace and program Mercedes ME 9.7? Possible to do it within 300 usd? Answer: There are usually 3 optional ways. And the cheapest is 299 usd for all. Optional solutions: There are 3 solutions available if you have a ME 9.7 ECU damaged! Method ECU Programmer Adapter Cost Expensive (the dealership) Original ME 9.7 ecu from the Mercedes dealership Original SD connect C4 f...
Pogledaj dalje »Hello, Possible to read Opel Corsa with Ktag clone, the red board? I am using Ktag 7.020 for Marelli 6JO Opel Corsa. Failed to read out ECU data. It says connection error. Help please. Obdii365.com tech support: Hello, Opel Corsa comes with ECU Marelli 6JO. For this ECU, you’d better go with a MPPS cable. MPPS V18 is good at Marelli. Covers more Marelli ECUs than Ktag Look at the customer r...
Pogledaj dalje »Problem: Try to read ecu from Mercedes W204 2.2 CDI 100kW. I use KSuite 2.13 and KTAG EU 7.020 via BDM. Trying Read it via protocol (Delphi DCM3.2 MERCEDES P119) but without success. After identifying ECU … i get response: Hardware configuration not supported: send the LOG files to the software provider. BDM connections is the same as in the HELP in KSuite. How correctly READ and WRITE this ecu by...
Pogledaj dalje »Purpose: Read a Magneti Marelli 8GMK from an Abarth 124 Optional ECU programming tool: Kess V2 firmware 5.017 and Ktag firmware 7.020 Basic info: 500x with same ecu is supported by Kess 5.017 (protocol 532), but 124 has a new protocol, the 576. Doubt: Is there a possibility to read it with this ksuite updated or users need a new Kess firmware 5.028 with 2.34 (8gmk for 124 wa implemented in 2.32). ...
Pogledaj dalje »